My calibration map / table is not working

By far, the most common reason for this issue is that the variable names do not follow the required naming convention.

Map / Table calibration variables must adhere to the following naming convention:

• The 4th character must be 'm'

• All variables associated with the table must have the same name, except for the last two characters
• The last two characters of the variable name must be '_x' for the input x-axis, '_y' for the input y-axis (2-D maps only),

and '_z' for the output axis.

Example: 1-D map

Assume you are trying to map voltage to temperature using a 1-D table. Your x-axis (input axis) will be in units of volts, while your z-axis (output axis) will be in units of degrees C. Then your map variables could be as follows:

• x-axis (1-D vector): INPm_volts2degc_x
• z-axis (1-D vector): INPm_volts2degc_z

Example: 2-D map

Assume you are trying to create a spark advance map using mass airflow and RPM as your inputs. Your x-axis (input axis) will be in units of grams of air, your y-axis (input axis) will be in units of RPM, and your z-axis (output axis) will be in units of degrees before TDC. Then your map variables could be as follows:

• x-axis (1-D vector): SPKm_sparkMap_x
• y-axis (1-D vector): SPKm_sparkMap_y
• z-axis (2-D matrix): SPKm_sparkMap_z

This did not solve my problem